Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 50)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
34 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Identifica-
tion Description Commands
.GMA Maximum gas flow rate in mL/min MEAS T/Flow
.GMI Minimum gas flow rate in mL/min MEAS T/Flow
.GMN Average gas flow rate in mL/min MEAS T/Flow
.GP.VOL Volume for Gran endpoint in mL DET, MET
.GP.MEA Measured value for the Gran end-
point in the unit of the measured
value DET, MET
.GP.TEM Temperature for Gran endpoint in
°C DET, MET
.GP.TIM Time for Gran endpoint in s DET, MET
.HP{x}.MEA Measured value for the HNP x (1…
9) in mV (HNP = half neutralization
potential) DET, MET
.HP{x}.TEM Temperature for the HNP x (1…9)
in °C DET, MET
.HP{x}.TIM Time in s until the HNP x (1...9) is
reached DET, MET
.HP{x}.VOL Volume for the HNP x (1…9) in mL DET, MET
.IGF Initial gas flow (measured value at
the time of the start of the com-
mand) in mL/min MEAS T/Flow
.IME Initial measured value (measured
value before start conditions are
processed) in the unit of the meas-
ured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL
MEAS, STDADD,
DOS
.ITE Initial temperature (temperature
before start conditions are pro-
cessed) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
MEAS, STDADD,
DOS