Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1192)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1176 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Stop criteria
Definition of possible stop criteria. The first stop criterion to be fulfilled will
stop the command.
Maximum run time
on | off (Default value: off)
Check box for switching on/off the stop criterion Maximum run time. If
the maximum run time is reached, then the command will be stopped.
Range 0 ... 999.9
Default value 0
Selection min | s
Default value min
Note
The run time is interrupted if the method is stopped with [HOLD].
Condition
on | off (Default value: off)
Check box for switching on/off the stop criterion Condition.
Expression for the condition(s) which can be created or edited with the for-
mula editor after pressing on or double-clicking in the text field (see
Chapter 2.4, page 23).
The condition is monitored on a continuous basis; if it is fulfilled (evaluation
of the formula gives the result 1 = true), then the command will be inter-
rupted.
Input 1000 characters
Default value empty
5.6.11.6 STEPPING MOTOR
5.6.11.6.1 STEPPING MOTOR - Overview
Dialog window: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR -
'Command name'
Devices
This command can be executed with the Stepping Motor Controller.
Appearance
The command has the following appearance: