Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 160)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
144 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
￭ Interrupt and continue series
A series that is running can be interrupted at any time with [Pause].
When this is done, the ongoing determination of the sample series will
still be carried out to completion, but no new determination will be star-
ted. The next determination of the interrupted sample series us started
with [Cont].
￭ Cancel run
A determination that is running can be canceled at any time with
[Stop]. The exit track (if present) is run afterwards and the determina-
tion is stopped.
￭ Stop by error
If an error occurs while a determination is running that causes the deter-
mination to be interrupted, then the error track will be run (if present)
and the determination will be ended.
￭ Process exit track
If the main track and all of the tracks that it has called up are stopped,
then the exit track (if present) will be run and the determination finished.
￭ Process series end track
The series end track is started at the end of the last determination of
a series. If [Stop] is pressed during the running of this track, then the
determination will be ended; if an error occurs, then the error track will
be.
7 - Conditioning (only for methods with conditioning)
In the case of methods which contain commands with conditions switched
on and for which the option Automatic conditioning is switched on in
the START command, conditioning with the method loaded will be started
automatically for all of these commands, immediately after the end of the
track which contains the conditioning command. After conditioning starts,
the status switches to COND BUSY. In this status, conditioning can be can-
celed with [Stop] or interrupted with [Hold] and resumed with [Cont]. If
an error occurs during conditioning, then neither the error track nor the exit
track will be run through.
In the case of methods which contain commands with conditions switched
on and for which the option Automatic conditioning is switched on in
the START command, conditioning with the method loaded will be started
automatically for all of these commands, immediately after the end of the
track which contains the conditioning command.
￭ Conditioning condition not fulfilled
After conditioning starts, the status switches to COND BUSY. A new
determination can be started in this status with [Start], even though the
conditioning requirement is not fulfilled. Conditioning can also be can-
celed with [Stop] or interrupted with [Hold] and resumed with [Cont].
If an error occurs during conditioning, then neither the error track nor
the exit track will be run through.