Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 664)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
648 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
of the working life, the validity of the titer and the GLP test interval for the
selected solution.
Selection 'Solution name' | not defined
Default value not defined
not defined
No tests will be carried out.
Sensor
Measuring input
Selection of the measuring input to which the sensor is connected.
Titrando
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1
Titrino
Selection
1 | 2 | diff.
Default value 1
Sensor
Selection of a sensor of type pH electrode from the list of sensors available
in the sensor table. The calibration data for the sensor will be adopted for
the determination.
Selection Sensor name | pH electrode
Default value pH electrode
Temperature measurement
Type of temperature measurement.
Titrando, 855
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then be
measured continuously.
automatic
If a temperature sensor is connected then the temperature will be meas-
ured continuously. Otherwise the temperature entered manually under
Temperature on the Titration parameters tab will used.