Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 149)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 133
Confirmation necessary to accept data during the determination.
on | off (Default value: off)
If this option is switched on, then data will not be imported during a deter-
mination except when the Data input dialog of a REQUEST command is
open.
3.6.3.10 Modification comment for sample data
Dialog window: Workplace ▶ Run ▶ Single determination ▶ Live
modifications ▶ Live modifications ▶ Modification comments sam-
ple data
Dialog window: Workplace ▶ Sequence ▶ Determination ser-
ies ▶ [Edit] ▶ Edit line ▶ Edit line - Working sample table - Workplace
'Name' ▶ Modification comment sample data
If the option Comment on modification of sample data (live) is enabled
in the security settings, then this window must be opened before saving. A
reason and a comment on the modification must be entered here (see
Chapter 6.2.2.4, page 1207).
Reason
Selection from the standard reasons for the category Modifications of
sample data (see Chapter 6.2.2.6, page 1209) that are defined in the
security settings.
Selection Selection from default reasons
Comment
Entry of remarks about the modifications to the sample data.
Input 1000 characters
3.6.4 Determination series
3.6.4.1 Determination series - Overview
Tab: Workplace ▶ Run ▶ Determination series
Parameters and sample data for determination series can be edited and run
functions can be triggered on the tab Determination series in the sub-
window Run. It contains the following tools and functions:
￭ Operating elements
Buttons for starting, stopping, interrupting and resuming determinations
and series.
￭ Status display
Shows the current status of the workplace.