Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 938)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
922 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Window = Measured value
Range
-20.0 ... 150.0 °C
Default value 150.0 °C
Window = Time
Range
1 ... 999999 s
Default value 999999 s
5.6.4.6.5 MEAS T - Additional measured values
Tab: Method ▶ MEAS T ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined here which can
then be saved together with the measured values present in the default
settings in additional measured value columns Calculated # or External
# in the measuring point list.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can be
calculated from existing measured values and saved, which can also be pre-
sented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be entered (see Chapter
5.6.3.10.1, page 858).
[Properties]
Opens the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be edited (see Chapter
5.6.3.10.1, page 858).
[Delete]
Deletes the calculated measured value selected in the table.