Lenze I/O system 1000 System Manual - Manual (Page 621)

PROFINET communication
Project planning
12
l
621 EDSIO1000 EN 7.0
12.3 Project planning
Project planning is carried out as hardware configuration in your PROFINET configuring
tool as for example the Siemens SIMATIC Manager. Here, you assign your I/O controller to
the appropriate I/O device. A direct assignment is made via the PROFINET address that can
be set at the I/O device via the address switch and the in I/O device properties.
By implementing the corresponding GSDML file, the PROFINET I/O bus coupler EPM−S140
is specified under:
PROFINET IO −> More field devices −> I/O > I/O system 1000
GSDML file
Lenze provides you with a GSDML file for the I/O device. This file is either located on the
enclosed data medium or in the download area of www.lenze.de. Install the GSDML file in
your configuring tool. More information on how to install the GSDML file can be found in
the manual of your configuring tool.
For operating with your configuring tool, the GSDML file contains all I/O compound
modules as XML files.
After installing the GSDML file, you can find the I/O system 1000 in the hardware catalogue
of Siemens under:
PROFINET IO > More field devices > I/O > I/O system 1000
Commissioning
ƒ Set up your PROFINET system.
ƒ Start your configuring tool with a new project.
ƒ Configure a master system and create a new
ƒ PROFINET subnetwork.
ƒ For configuring the bus coupler, select the "EPM−S140" from the hardware catalogue
and drag it to the PROFINET subnetwork.
ƒ As soon as all switches of the address switch have the 0 status, the "DeviceName"
can be assigned freely via the properties of the PROFINET bus coupler. Otherwise
assign a PROFINET name via the switch position of the address switch.
ƒ If required, parameterise the I/O device.
ƒ Transfer your project into the PLC.