Lenze I/O system 1000 System Manual - Manual (Page 217)

Product description
I/O compound module − pulse width modulation
2 digital outputs with PWM functionality − EPM−S620
3
l
217 EDSIO1000 EN 7.0
EPM−S620: Rated data
Load voltage
Nominal value DC 24 (DC 20.4 ... 28.8 V)
Current consumption from load voltage
L+ 15 mA (without load)
Total current
for each group, horizontal structure,
40°C 1 A
for each group, horizontal structure,
60°C 1 A
for each group, vertical structure 1 A
Output current
for "1" signal, nominal value 0.5 A
Output delay
from "0" to "1" Max. 100 ns
from "1" to "0" Max. 100 ns
Lamp load 10 W
Parallel switching of outputs
for redundant control Not possible
for power increase Not possible
Control of a digital input Possible
Switching frequencies
for ohmic loads Max. 40 Hz
for inductive loads Max. 40 Hz
for lamp loads Max. 40 Hz
Limitation (internal) of the inductive
breaking voltage L+ (−52 V)
Short circuit protection of the output Electronically; only highside
Operating threshold of the protection
system 2.5 A
Input data size 4 bytes
Output data size 12 bytes
Status, alarm, diagnostics
Status display Green LEDs per channel
Alarms No
Process alarm No
Diagnostic alarm No
Diagnostic function No
Diagnostic information can be read out Possible
Module status Green LED
Module error display Red LED
Channel error display None
Electrical isolation
Between the channels and the backplane
bus Yes
Insulation checked with DC 500 V