Lenze I/O system 1000 System Manual - Manual (Page 32)

Product description
Bus coupler modules
CANopen − EPM−S110
3
l
32 EDSIO1000 EN 7.0
Setting the node address:
Coding switch − CAN address and baud rate (addr.) 3
View Pos. Valency
Example
Switching
status
Node address
"1" "0"
1
8
1 not assigned −
2 1 1
1 + 2 + 16 = 19 àaddress 19
3 2 1
4 4 0
5 8 0
6 16 1
7 32 0
SLIO004 8 64 0
5. Set the node address for the module with the coding switch.
– Device addresses permitted are 1 ... 127.
– Each node address must be assigned only once.
)
Note!
The node address can be changed any time by means of the coding switch. The
setting is accepted once the supply voltage is switched on.