Lenze I/O system 1000 System Manual - Manual (Page 411)

PROFIBUS communication
Setting the parameters of analog I/O
4 analog outputs 0 ... 10 V (12 bits) − EPM−S501
9
l
411 EDSIO1000 EN 7.0
Diagnostic data
Since this module does not support an alarm, the diagnostic data serve to provide
information on this module. In the event of an error the corresponding channel LED of the
module is lit and the error is entered in the diagnostic data.
The following errors are registered in the diagnostic data:
ƒ Configuration/parameterisation errors
ƒ Short circuit/overload (if parameterised)
Using SFB 52 you can access the diagnostic data of the module anytime. Data set 1 has the
following structure:
Byte Bit 7 ... 0
0 Bit 0: Set in the case of module fault
Bit 1: Set in the case of internal error
Bit 2: Set in the case of external error
Bit 3: Set if channel error available
Bit 4: Set in the case of a missing external supply voltage
Bit 6: 0 (fixed)
Bit 7: Parameterisation error
1 Bits 3 ... 0: Module class, 0101
b
: Analog module
Bit 4: Channel information available
Bit 7 ... 5: 0 (fixed)
2 0 (fixed)
3 0 (fixed)
4 Bit 6 ... 0: Channel type, 73
h
: analog output
Bit 7: 0 (fixed)
5 Number of diagnostic bits output by the module per channel (here 08
h
)
6 Number of channels of a module (here 04
h
:)
7 Bit 0: Channel error channel 1
Bit 1: Channel error channel 2
Bit 2: Channel error channel 3
Bit 3: Channel error channel 4
Bit 7 ... 4: 0 (fixed)
8 Channel−specific errors: channel 1:
Bit 0: Configuration/parameterisation error
Bit 2 ... 1: 0 (fixed)
Bit 3: Short circuit after M
Bit 7 ... 4: 0 (fixed)
9 Channel−specific errors: channel 2:
Bit 0: Configuration/parameterisation error
Bit 2 ... 1: 0 (fixed)
Bit 3: Short circuit after M
Bit 7 ... 4: 0 (fixed)
10 Channel−specific errors: channel 3:
Bit 0: Configuration/parameterisation error
Bit 2 ... 1: 0 (fixed)
Bit 3: Short circuit after M
Bit 7 ... 4: 0 (fixed)
11 Channel−specific errors: channel 4:
Bit 0: Configuration/parameterisation error
Bit 2 ... 1: 0 (fixed)
Bit 3: Short circuit after M
Bit 7 ... 4: 0 (fixed)
12 ... 15 0 (fixed)