Lenze I/O system 1000 System Manual - Manual (Page 341)

CANopen communication
Loading the default setting
8
l
341 EDSIO1000 EN 7.0
8.15 Loading the default setting
All parameter changes are reset to the default setting via index I1011
hex
.
The default setting is accepted by switching the supply off and on again. Changes that you
may have carried out before will be deleted from the EEPROM of the I/O system.
Index Name Possible settings Important
Lenze Selection
I1011
h
¿
Restore All
Parameters 0 Resetting the parameter setting
in the EEPPROM of the bus
coupler to the Lenze setting.
Function in accordance with
CANopen (DS301/DS401
communication protocol). ^ 340
0 Number of subindexes assigned Read only
Number of the subindexes used
by the index 1011
h
1 Load 0 = no function
1684107116
d
= load Lenze setting
The numerical value is
ASCII−coded and complies with:
64 61 6F 6C
h
= "D" "A" "O" "L"
After executing "Load",
acceptance is effected by
l Voltage off/on, or
l Transmission of a reset node
telegram (00 82 xx, mit xx =
node address)