Lenze I/O system 1000 System Manual - Manual (Page 54)

Product description
Bus coupler modules
DeviceNet − EPM−S150
3
l
54 EDSIO1000 EN 7.0
3.5.5 DeviceNet − EPM−S150
The bus coupler module represents the interface between the process level (I/O level) and
the higher−level fieldbus. The control signals on the process level are transmitted by the I/O
compound modules via the internal backplane bus.
Features
ƒ DeviceNet coupler
ƒ Up to 64 I/O compound modules can be connected to a DeviceNet bus coupler
module
ƒ Group 2 only Device uses Predefined Connection Set
ƒ Poll only Device
– No operating mode BIT STROBE
– NO operating mode CHANGE OF STATE
– Profile Generic Device
ƒ Support of all baud rates: 125, 250 und 500 kbps
ƒ Max. 255 bytes input/output data
ƒ Integrated power supply unit for the internal voltage supply and the voltage supply
of the connected I/O compound modules
– Power supply unit supplied via an external DC voltage source
ƒ Connection to the DeviceNet via "Open Style Connector"
ƒ Setting of the DeviceNet address and the baud rate via coding switch
ƒ LEDs for status display