Lenze I/O system 1000 System Manual - Manual (Page 39)

Product description
Bus coupler modules
PROFIBUS − EPM−S120
3
l
39 EDSIO1000 EN 7.0
Control elements
Via coding switch
3 the PROFIBUS node address is set. The setting is permanently stored
in EEPROM.
Coding switch − PROFIBUS address (addr.) 3
View Pos. Valency
Example
Switching
status
Node address
"1" "0"
1
8
1 Not assigned −
2 1 1
19
dec
peraddress: 19
3 2 1
4 4 0
5 8 0
6 16 1
7 32 0
SLIO004 8 64 0
How to proceed:
1. Switch off the voltage supply for the I/O system.
2. Set the node address with the coding switch
3.
– Permitted addresses: 1 ... 125
– Each node address within a fieldbus system must be non−ambiguous.
3. Switch on the voltage supply for the I/O system.