Lenze I/O system 1000 System Manual - Manual (Page 559)

DeviceNet communication
Access to the I/O system 1000
11
l
559 EDSIO1000 EN 7.0
11.2 Access to the I/O system 1000
The following illustration shows the access under DeviceNet to the areas "I/O",
"parameters" and "diagnostics".
EPM-S150 EPM-S200
DI 2x
DC24V
Slot 1
EPM-S301
DO 4x
DC24V
Slot 2
EPM-S400
AI 2x
12Bit
Slot 3
EPM-S701
Slot 4
EPM-S600
1x 32Bit
Slot 5
EPM-S201
DI 4x
DC24V
Slot 6
I data
O data
I data
Bytes:
1
O data
I data I data
Bytes:
4
Bytes:
12
Bytes:
1
Bytes:
1
Bytes:
10
Slot:
Output:
Slot:
Input:
1
2
3 4 5
4
DeviceNet Device (Slave)
Param:
1
2
3 4 5
4
Param Param
Diag Diag Diag Diag Diag
Diag:
DeviceNet-Slot: Slot 1 Slot 2 Slot 3 - Slot 4 Slot 5
I/O Mapping
Parameterization
DeviceNet Scanner (Master) Configuration tool
Diagnostic
SLIO067
)
Note!
Please note that the supply and terminal modules do not have any type
identification and thus cannot be recognised by the DeviceNet bus coupler.
In the following, slots within the DeviceNet are called DeviceNet slots.
Counting always starts at 1.
EDS file (Electronic Data Sheet)
For the DeviceNet bus coupler module EPM−S150, the EDS file
"Lenze−EPM−S150_64_10.eds" is available in the download area of www.Lenze.de. Install
this EDS file in your project planning tool. More information on how to install the EDS file
can be found in the manual of your project planning tool.