Lenze I/O system 1000 System Manual - Manual (Page 58)

Product description
Bus coupler modules
DeviceNet − EPM−S150
3
l
58 EDSIO1000 EN 7.0
Setting the DeviceNet address:
All stations on the bus must be uniquely identified by means of a DeviceNet address which
is between 0 and 63. Proceed as follows to define the baud rate:
1. Switch off the voltage supply.
2. Set the switch 1 to "0" (address).
3. Set the address via switches 2 ... 4 according to the following table.
DeviceNet address 3
View Pos. Valency
Example
Switching
status
Result
"1" "0"
1
8
1 Configuration 0 0: Address setting
2 1 1
1 + 2 + 16 = 19 per address: 19
3 2 1
4 4 0
5 8 0
6 16 1
7 32 0
SLIO004 8 Not assigned −
4. Switch on the voltage supply.
The set node address is saved in the EEPROM. In case of a wrong or already available
address the SF−LED (red) is lit after PowerON.
Setting the update mode:
Set the update mode to transmit a firmware to the bus coupler.
How to proceed:
1. Switch off the voltage supply.
2. Set the switch 1 to "1" (= baud rate/update mode).
3. Set the update mode via switches 2 ... 4 according to the following table.