Lenze I/O system 1000 System Manual - Manual (Page 12)

About this documentation 1
l
12 EDSIO1000 EN 7.0
1 About this documentation
Contents
This documentation informs you about the intended use of the components of the I/O
system 1000.
Target group
This documentation is intended for all persons who design, install, set up, and adjust the
I/O system 1000.
I
Tip!
Information and auxiliary devices related to the Lenze products can be found
in the download area at
http://www.Lenze.com
Validity
The information given in this documentation applies to the components of the I/O system
1000 according to the following module labelling:
2 6
3 7
4 8
1 5
X1
DC 24V
- +
CAN
RUN
ERR
BA
IF
1
2
3
4
5
6
7
8
0 1
Adr.
1
2
3
4
Speed
0 1
L/C
‚
ƒ
2 6
3 7
4 8
1 5

‚
ƒ

SLIO003
Fig. 1−1 Labelling of the modules
 Module designation according to the following table (e.g. AI 2, 12 bits, DC 0 ...10 V)
‚ Type designation according to the following table (e.g. EPM−S400)
ƒ Hardware version/software version according to the following table (e.g. 1A.10)