Lenze I/O system 1000 System Manual - Manual (Page 57)

Product description
Bus coupler modules
DeviceNet − EPM−S150
3
l
57 EDSIO1000 EN 7.0
Control elements
The coding switch serves for the following settings:
ƒ Baud rate
ƒ DeviceNet address
ƒ Update mode for firmware update
)
Note!
Changes at the coding switch get only effective after PowerON or automatic
reset. Changes during operation will not be recognised!
Setting the baud rate:
Every station on the DeviceNet communicates with the same transfer rate. Proceed as
follows to define the baud rate:
1. Switch off the voltage supply.
2. Set the switch 1 to "1" (= baud rate).
3. Set the baud rate via switches 2 ... 4 according to the following table.
Baud rate 3
View Pos. Description
Example
Switching
status
Result
"1" "0"
1
8
1 Configuration 1 1: Setting of baud rate/update mode
2
Baud rate
125 kbps
0
Baud rate: 250 kbps
3
Baud rate
250 kbps
1
4
Baud rate
500 kbps
0
5 Not assigned −
6 Not assigned −
7 Update mode 0
SLIO004 8 Not assigned −
4. Switch on the voltage supply.
The set baud rate is stored in the EEPROM.