Lenze I/O system 1000 System Manual - Manual (Page 47)

Product description
Bus coupler modules
EtherCAT − EPM−S130
3
l
47 EDSIO1000 EN 7.0
Terminals
Module terminals, spring terminals 2
View Designation Explanation Terminal data
2 6
3 7
4 8
1 5 1 5
4 8
1 Not assigned
10 mm
0.08 ... 1.5 mm²
(AWG 28 ... 16)
2 I/O supply +24 V DC
3 I/O supply 0 V
4 Electronic supply +24 V DC
5 Not assigned
6 I/O supply +24 V DC
7 I/O supply 0 V
SLIO002 8 Electronic supply 0 V
)
Note!
ƒ Terminals 2 and 6 as well as 3 and 7 are bridged internally. Please note that
the max. permissible bridge current is 5 A.
ƒ Both the I/O supply and the electronic supply are protected against overload
internally by a fuse. When the fuses have been tripped, the main supply of
the bus coupler (EPM−S700) must be replaced (
¶ 726).
EtherCAT, RJ45 socket 4, 5
View Pin Assignment Explanation
8 1
1 Transmit + Transmitted data plus
2 Transmit − Transmitted data minus
3 Receive + Received data plus
4 − Not assigned
5 − Not assigned
6 Receive − Received data minus
7 − Not assigned
8 − Not assigned
SLIO065 9 − Not assigned
Technical data
EPM−S130: rated data
Electrical data
Supply voltage
Nominal value DC 24 V
Permissible range DC 20.4 ... 28.8 V
Current consumption
Nominal value 0.95 A
In idle state 0.095 A
Starting current 2.8 A
I 2 t 0.25 A 2 s
Current output, max.
At the backplane bus 3 A
Load supply 7 A (if no UL conformity is required: max. 10 A)
Polarity reversal protection No
Power loss 3 W