Lenze I/O system 1000 System Manual - Manual (Page 136)

Product description
I/O compound modules − analog I/O
4 analog outputs 0 ... 10 V (12 bits) − EPM−S501
3
l
136 EDSIO1000 EN 7.0
Status displays
Module status LEDs 0
View Pos. Designation Colour Explanation
1
10
1 RUN Green On: Module is ready for operation
2 MF Red On: Module error (see table below)
3 AO1 Red
Channel 1, overload, short−circuit, error in
parameter setting
4 AO2 Red
Channel 2, overload, short−circuit, error in
parameter setting
5 AO3 Red
Channel 3, overload, short−circuit, error in
parameter setting
6 AO4 Red
Channel 4, overload, short−circuit, error in
parameter setting
7
− − Not assigned
8
9
SLIO001 10
Messages of the status LEDs RUN and MF
RUN MF Meaning
On Off
Module status OK
Bus communication is OK
On On
Module reports error
Bus communication is OK
Off On
Module reports error
Bus communication not possible
Off Off Error in the bus supply voltage
Blinking Blinking Configuration error ( ^ 249)
Terminals
Module terminals, spring terminals 1
View Designation Explanation Terminal data
2 6
3 7
4 8
1 5 1 5
4 8
1 Analog output AO1 (+)
10 mm
0.08 ... 1.5 mm²
(AWG 28 ... 16)
2 Analog output AO1 (GND)
3 Analog output AO3 (+)
4 Analog output AO3 (GND)
5 Analog output AO2 (+)
6 Analog output AO2 (GND)
7 Analog output AO4 (+)
SLIO002 8 Analog output AO4 (GND)
)
Note!
ƒ When connecting the actuators, make sure that the polarity is correct.
ƒ Outputs that are not used are not connected.
ƒ The module does not provide any auxiliary supply for actuators.