Lenze I/O system 1000 System Manual - Manual (Page 133)

Product description
I/O compound modules − analog I/O
2 analog outputs 0 ... 10 V (12 bits) − EPM−S500
3
l
133 EDSIO1000 EN 7.0
Technical data
EPM−S500: Rated data
Module identifier 1281
dec
Current consumption/power loss
Current consumption from backplane bus 80 mA
Power loss 1.2 W
Analog outputs
Number of outputs 2
Cable length
shielded 200 m
Load voltage
Nominal value DC 24 V
Current consumpt. from load voltage L+ 35 mA (without load)
Voltage outputs
Output voltage ranges 0 V ... +10 V
Min. load impedance 5 k W
Max. capacitive load 1 mF
Operational error limit +/− 0.3 %
Basic error limit +/− 0.2 %
Short circuit protection Yes
Voltage at the outputs 15 V
Current 30 mA
Interference suppression (cross−talk
between the outputs) > 40 dB
Resolution 12 bits
Basic conversion time 2 ms all channels
Substitute values can be applied Yes
Temperature error
(relating to the output range) ± 0.01 %/K
Linearity distortion
(relating to the output range) ± 0.1 %
Output ripple; bandwidth 0 to 50 kHz
(relating to the output range) ± 0.05 %
Repeat accuracy (in steady−state vibration at
25°C, relating to the output range) ± 0.05 %
Dwell time
for ohmic loads 1.5 ms
for capacitive loads 2 ms
Output data size 4 bytes
Status, alarm, diagnostics
Status display Yes
Alarms No
Process alarm No
Diagnostic alarm No
Diagnostic function Yes
Diagnostic information can be read out Possible
Module status Green LED
Module error display Red LED
Channel error display Red LEDs per channel