Canopen communication – Lenze I/O system 1000 System Manual User Manual
Page 307
CANopen communication
Parameterising the temperature measurement
Two analog inputs for thermocouple measurement − EPM−S405
l
307
EDSIO1000 EN 7.0
Lenze
Description/value
Name
Index/sub
index
0x3107/x Conversion time
channel 1
You can set the transformer speed as a function of the
interference frequency suppression (see 0x3105/x) for each
channel.
0 (00
h
): At 50 Hz: 324.1 ms/channel 16 bits; at 60 Hz:
270.5 ms/channel 16 bits
1 (01
h
): at 50 Hz: 164.2 ms/channel 16 bits; at 60 Hz:
137.2 ms/channel 16 bits
2 (02
h
): At 50 Hz: 84.2 ms/channel 16 bits; at 60 Hz:
70.5 ms/channel 16 bits
3 (03
h
): at 50 Hz: 44.1 ms/channel 16 bits; at 60 Hz:
37.2 ms/channel 16 bits
4 (04
h
): At 50 Hz: 24.2 ms/channel 16 bits; at 60 Hz:
20.5 ms/channel 16 bits
5 (05
h
): at 50 Hz: 14.2 ms/channel 16 bits; at 60 Hz:
12.2 ms/channel 16 bits
6 (06
h
): at 50 Hz: 9.2 ms/channel 16 bits; at 60 Hz:
8.0 ms/channel 16 bits
7 (07
h
): at 50 Hz: 6.6 ms/channel 15 bits; at 60 Hz:
5.9 ms/channel 15 bits
8 (08
h
): at 50 Hz: 4.2 ms/channel 13 bits; at 60 Hz:
3.8 ms/channel 13 bits
02
h
0x3108/x Upper limit value
(HIGH byte) channel 1 You can define an upper or lower limit value for each channel.
For this you can only specify values from the nominal range,
otherwise you’ll receive a parameterisation error. By
specification of 7FFFh for the upper or 8000h for the lower limit
value, the corresponding limit value is deactivated.
If your measured value is outside a limit value and you have
activated the limit value monitoring, a process alarm is
triggered.
7F
h
0x3109/x Upper limit value
channel 1 (LOW byte)
FF
h
0x310A/x Lower limit value
(HIGH byte) channel 1
80
h
0x310B/x Lower limit value
channel 1 (LOW byte)
00
h
Channel 2
0x310C/x Function channel 2
See channel 1
C1
h
0x310D/x Conversion time
channel 2
See channel 1
02
h
0x310E/x Upper limit value
channel 2 (HIGH byte)
7F
h
0x310F/x
Upper limit value
(LOW byte) channel 2
FF
h
0x3110/x Lower limit value
channel 2 (HIGH byte)
80
h
0x3111/x Lower limit value
(LOW byte) channel 2
00
h
0x3112/x Reserved
0
...
...
...
0x311D/x Reserved
0