Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 972)

960 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points.
3. Select WIPS and expand the menu to reveal its sub menu items.
4. Select WIPS Events.
FIGURE 154 Access Point - WIPS Events screen
The WIPS Events screen provides the following:
Sensor Servers
Access Point Statistics
Sensor servers allow the monitor and download of data from multiple sensors and remote
locations using Ethernet TCP/IP or serial communication. Repeaters are available to extend the
transmission range and combine sensors with various frequencies on the same receiver.
To view the network address and status information of the sensor server resources available to the
Access Point:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points.
Event Name Displays the name of the detected wireless intrusion event.
Reporting AP Displays the MAC address of the Access Point reporting the listed intrusion.
Originating Device Displays the MAC address of the intruding device.
Detector Radio Displays the number of the detecting Access Point radio.
Time Reported Displays the time when the intrusion event was detected.
Clear All Select the Clear All button to clear the screen of its current status and begin a new data collection.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.