Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 960)

948 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
FIGURE 144 Access Point - Firewall Denial of Service screen
The Denial of Service screen displays the following:
IP Firewall Rules
Firewall
Create firewall rules to let any computer to send traffic to, or receive traffic from, programs, system
services, computers or users. Firewall rules can be created to take one of the three actions listed
below that match the rule’s criteria:
• Allow a connection
• Allow a connection only if it is secured through the use of Internet Protocol security
• Block a connection
Rules can be created for either inbound or outbound traffic. To view the IP firewall rules:
1. Select the Statistics menu from the Web UI.
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points.
3. Select Firewall and expand the menu to reveal its sub menu items.
4. Select IP Firewall Rules.
Attack Type Displays the Denial of Service (DoS) attack type.
Count Displays the number of times the Access Point’s firewall has detected each listed DoS attack.
Last Occurrence Displays the when the attack event was last detected by the Access Point firewall.
Clear All Select the Clear All button to clear the screen of its current status and begin a new data collection.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.