Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 446)

434 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
5. Select the L2TPv3 Tunnel tab.
FIGURE 31 Network - L2TPv3 screen, T2TP tunnel tab
6. Review the following L2TPv3 tunnel configuration data:
7. Either select Add to create a new L2TPv3 tunnel configuration, Edit to modify an existing tunnel
configuration or Delete to remove a tunnel from those available to this profile.
Name Displays the name of each listed L2TPv3 tunnel assigned upon creation.
Local IP Address Lists the IP address assigned as the local tunnel end point address, not the interface IP
address. This IP is used as the tunnel source IP address. If this parameter is not specified,
the source IP address is chosen automatically based on the tunnel peer IP address.
MTU Displays the maximum transmission unit (MTU) size for each listed tunnel. The MTU is the
size (in bytes) of the largest protocol data unit that the layer can pass between tunnel peers.
Use Tunnel Policy Lists the L2TPv3 tunnel policy assigned to each listed tunnel.
Local Hostname Lists the tunnel specific hostname used by each listed tunnel. This is the host name
advertised in tunnel establishment messages.
Local Router ID Specifies the router ID sent in the tunnel establishment messages.
Establishment Criteria Specifies the criteria required for a tunnel between two peers.
Critical Resource Specifies the critical resource that should exist for a tunnel between two peers.
Peer IP Address Specifies the IP address of the tunnel peer device.
Host Name Specifies the host name of the tunnel device.