Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 432)

420 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
Select either Inline or Promiscuous mode to allow the packets the radio is switching to also
be used by the WIPS analysis module. This feature can be enabled in two modes: an inline
mode where the wips sensor receives the packets from the radios with radio operating in
normal mode. A promiscuous mode where the radio is configured to a mode where it
receives all packets on the channel whether the destination address is the radio or not,
and the wips module can analyze them.
10. Select the WLAN Mapping/Mesh Mapping tab.
FIGURE 23 Access Point Radio - WLAN Mapping/Mesh Mapping screen
11. Refer to the WLAN/BSS Mappings field to set WLAN BSSID assignments for an existing Access
Point deployment.
Administrators can assign each WLAN its own BSSID. If using a single-radio Access Point, there are
8 BSSIDs available. If using a dual-radio Access Point there are 8 BSSIDs for the 802.11b/g/n
radio and 8 BSSIDs for the 802.11a/n radio.
12. Select Advanced Mapping to enable WLAN mapping to a specific BSS ID.
13. Select OK to save the changes to the WLAN Mapping. Select Reset to revert to the last saved
configuration.
14. Select the Legacy Mesh tab.