Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 374)

362 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
7
FIGURE 13 AAA TACACS Policy - Accounting Server
NOTE
Only 2 AAA TACACS accounting servers can be configured at a time.
10. Define the following settings to add or modify AAA TACACS accounting server configuration:
Click OK to save the changes, Reset to revert to the last saved configuration or Exit to close the
screen.
Select the Authorization tab.
Server Id Set numerical server index (1-2) for a new accounting server.
Host Specify the IP address or hostname of the AAA TACACS accounting server.
Port Define or edit the port on which the AAA TACACS server listens to traffic. The port range is 1 -
65,535. The default port is 49.
Secret Specify (and Reconfirm) the secret (password) used between the selected AAA TACACS accounting
server and the controller, service platform or Access Point. By default the secret displays as
asterisks.
Request Attempts Set the number of connection request attempts to the TACACS server before it times out of the
accounting session. The available range is from 1 - 10. The default is 3.
Request Timeout Specify the time for the re-transmission of request packets after an unsuccessful attempt. The
default is 3 seconds. If the set time is exceeded, the session is terminated.
Retry Timeout Factor Set the scaling of retransmission attempts from 50 - 200 seconds. The timeout at each attempt is
the function of the retry timeout factor and the attempt number. 100 (the default value) implies a
constant timeout on each retry. Smaller values indicate more aggressive (shorter) timeouts. Larger
numbers define more conservative (larger) timeouts on each successive attempt.