Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 437)

Brocade Mobility RFS Controller System Reference Guide 425
53-1003099-01
8
FIGURE 26 Profile -WAN Backhaul screen
4. Refer to the WAN (3G) Backhaul configuration to specify WAN card settings:
5. Set the following authentication parameters from within the Basic Settings field:
WAN Interface Name Displays the WAN Interface name for the WAN 3G Backhaul card.
Enable WAN (3G) Select this option to enable 3G WAN card support on the device. A supported 3G card
must be connected to the device for this feature to work.
Username Provide a 32 character maximum username for authentication support by the cellular
data carrier.
Password Provide a password for authentication support by the cellular data carrier.
Access Point Name
(APN) Enter the administrator assigned name of the Access Point. This setting is needed in
areas with multiple cellular data providers using the same protocols such as Europe,
the middle east and Asia.
Authentication Type Use the drop-down menu to specify authentication type used by your cellular data
provider. Supported authentication types are None, PAP, CHAP, MSCHAP, and
MSCHAP-v2.