Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 909)

Brocade Mobility RFS Controller System Reference Guide 897
53-1003099-01
15
2. Select System from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points.
3. Select AP Detection.
FIGURE 107 Access Point - AP Detection
The AP Detection screen displays the following:
Wireless Clients
Access Point Statistics
Unsanctioned AP Displays the MAC address of a detected Access Point that is yet to be authorized for interoperability
within the Access Point managed network.
Reporting AP Displays the hardware encoded MAC address of the radio used by the detecting Access Point. Select an
Access Point to display configuration and network address information in greater detail.
SSID Displays the WLAN SSID the unsanctioned Access Point was detected on.
AP Mode Displays the operating mode of the unsanctioned Access Point.
Radio Type Displays the type of the radio on the unsanctioned Access Point. The radio can be 802.11b, 802.11bg,
802.1bgn, 802.11a or 802.11an.
Channel Displays the channel the unsanctioned Access Point is currently transmitting on.
RSSI Lists a relative signal strength indication (RSSI) for a detected (and perhaps unsanctioned) Access Point.
Last Seen Displays the time (in seconds) the unsanctioned Access Point was last seen on the network.
Clear All Select the Clear All button to clear the screen of its current status and begin a new data collection.
Refresh Select the Refresh button to update the screen’s statistics counters to their latest values.