Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 727)

Brocade Mobility RFS Controller System Reference Guide 715
53-1003099-01
14
Re-elect Controller
Device Operations
Use the Controller Re-election screen to identity available Access Point resources within a selected
RF Domain and optionally make some, or all, of the Access Points available to initiate tunnel
connections.
NOTE
Take care when selecting Access Points for controller re-election, as client connections may be
broken on upon re-election. Ensure an elected Access Point's client load can be compensated by
another Access Point in the same RF Domain.
To re-elect controller adoption resources for tunnel establishment:
NOTE
The Re-elect Controller tab is only available at the RF Domain level of the UI’s hierarchal tree and is
not available for individual controllers, service platforms and Access Points.
Select Operations.
6. Ensure a RF Domain is selected from the Operations menu on the top, left-hand, side of the
screen. Otherwise, the Re-elect Controller screen cannot be located, as it does not display at
either the system or device levels of the hierarchal tree.
7. Select the Re-elect Controller tab.
FIGURE 14 Re-elect Controller screen