Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 358)

346 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
7
NOTE
If connecting an Ethernet port to another Ethernet port, the pseudowire type must be Ethernet port,
if connecting an Ethernet VLAN to another Ethernet VLAN, the pseudowire type must be Ethernet
VLAN.
To define an L2TP V3 tunnel configuration:
Select Configuration > Network > L2TP V3.
FIGURE 1 L2TP V3 Policy screen
The L2TP V3 screen lists the policy configurations defined thus far.
Refer to the following to discern whether a new L2TP V3 requires creation or modification:
Name Lists the 31 character maximum name assigned to each listed L2TP V3 policy, designated upon
creation.
Cookie size Displays the size of each policy’s cookie field present within each L2TP V3 data packet. L2TP V3
data packets contain a session cookie which identifies the session (pseudowire) corresponding
to it. If using the CLI, cookie size can't be configured per session, and are the same size for all
sessions within a tunnel.
Hello Interval Displays each policy’s interval between L2TP V3 hello keep alive messages exchanged within
the L2TP V3 control connection.
Reconnect Attempt Lists each policy’s maximum number of reconnection attempts available to reestablish the
tunnel if the connection is lost.
Reconnect Interval Displays the duration set for each listed policy between two successive reconnection attempts.
Retry Count Lists the number of retransmission attempts set for each listed policy before a target tunnel
peer is defined as not reachable.
Retry Time Out Lists the interval the interval (in seconds) set for each listed policy before the retransmission of
a L2TP V3 signaling message.