Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 151)

Brocade Mobility RFS Controller System Reference Guide 139
53-1003099-01
5
11. Refer to the Peer table to review the configurations of the peers destinations for tunnel
connection.
Select + Add Row to populate the table with a maximum of two peer configurations.
FIGURE 55 Network - L2TPv3 screen, Add T2TP Peer Configuration
12. Define the following Peer parameters:
Establishment Criteria Specify the establishment criteria for creating a tunnel. The tunnel is only created if this
device is one of the following:
vrrp-master
cluster-master
rf-domain-manager
The tunnel is always created if Always is selected. This indicates the device need not be
any one of the above three (3) to establish a tunnel.
VRRP Group Set the VRRP group ID. VRRP groups is only enabled when the Establishment Criteria is
set to vrrp-master.
Critical Resource The Critical Resources table lists important resources defined for this system. The
tunnel is created and maintained only if these critical resources are available. The
tunnel is removed if any one of the defined resources goes down or is unreachable.
Peer ID Define the primary peer ID used to set the primary and secondary peer for tunnel fail
over. If the peer is not specified, tunnel establishment does not occur. However, if a
peer tries to establish a tunnel with this Access Point, it creates the tunnel if the
hostname and/or Router ID matches.
Peer IP Address Select this option to enter the numeric IP address used as the destination peer address
for tunnel establishment.
Hostname Assign the peer a hostname that can be used as matching criteria in the tunnel
establishment process.
Router ID Specify the router ID sent in tunnel establishment messages with this specific peer.