Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 506)

494 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
4. Select Security.
5. Select Auto IPSec Tunnel.
FIGURE 72 Security Auto IPSec Tunnel screen
6. The Auto IPSec Tunnel screen displays by default. Refer to the Settings field to set an Auto
IPSec Tunnel configuration for use with this profile.
7. Select OK to save the changes made to the auto IPSec tunnel configuration. Select Reset to
revert to the last saved configuration.
Setting the Profile’s NAT Configuration
Profile Security Configuration
Group ID Define a 1 - 64 character group identifier for an IKE exchange supporting auto IPSec tunnel secure
peers.
Authentication Type Use the drop-down menu to select either RSA or PSK (Pre Shared Key) as the authentication type for
secure peer authentication on the auto IPSec secure tunnel. Rivest, Shamir, and Adleman (RSA) is an
algorithm for public key cryptography. It’s the first algorithm known to be suitable for signing, as well
as encryption. The default setting is RSA.
Authentication Key Enter the 8 - 21 character shared key (password) used for auto IPSec tunnel secure peer
authentication.
IKE Version Use the drop-down menu to select the IKE version used for auto IPSec tunnel secure authentication
with the IPSec gateway.
Enable NAT after IPSec Select this option to enable internal source port NAT on the auto IPSec secure tunnel.
Use Unique ID Select this option to use a unique ID with auto IPSec secure authentication for the IPSec remote
gateway (appending the MiNT ID). This setting is disabled by default.