Ldap agent status – Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 941
Brocade Mobility RFS Controller System Reference Guide
929
53-1003099-01
15
The Access Point Critical Resource screen displays the following:
LDAP Agent Status
When LDAP has been specified as an external resource (as opposed to local Access Point RADIUS
resources) to validate PEAP-MS-CHAP v2 authentication requests, user credentials and password
information needs to be made available locally to successfully connect to the external LDAP server.
Up to two LDAP Agents (primary and secondary external resources) can be defined as external
resources for PEAP-MS-CHAP v2 authentication requests.
BR6511 model Access Point do not support this feature in Standalone AP or Controller AP mode.
However, BR6511 model is supported when adopted and managed by a controller or service
platform.
For more information on setting LDAP agents as part of the RADIUS server policy, see
RADIUS Server Policies on page 11-643
To view Access Point LDAP agent statistics:
1. Select the
Statistics
menu from the Web UI.
2. Select
System
from the navigation pane (on the left-hand side of the screen). Expand a RF
Domain, select a controller or service platform, and select one of its connected Access Points.
3. Select
LDAP Agent Status
.
Critical Resource
Name
Lists the name of the critical resource monitored by the Access Point. Critical resources are device IP
addresses on the network (gateways, routers etc.). These IP addresses are critical to the health of the
network. These device addresses are pinged regularly by Access Points. If there’s a connectivity issue,
an event is generated stating a critical resource is unavailable.
Via
Lists the VLAN used by the critical resource as a virtual interface. The critical resource displays as a link
than can be selected to list configuration and network address information in greater detail.
Status
Defines the operational state of each listed critical resource VLAN interface (either Up or Down).
Error Reason
Provides an error status as to why the critical resource is not available over its designated VLAN.
Mode
Displays the operational mode of each listed critical resource.
Refresh
Select the Refresh button to update the screen’s statistics counters to their latest values.