Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 553)

Brocade Mobility RFS Controller System Reference Guide 541
53-1003099-01
8
FIGURE 105 Advanced Profile Miscellaneous screen
Set a NAS-Identifier Attribute up to 253 characters.
This is the RADIUS NAS-Identifier attribute that typically identifies the controller or service
platform where a RADIUS message originates.
Set a NAS-Port-Id Attribute up to 253 characters in length.
This is the RADIUS NAS port ID attribute which identifies the device port where a RADIUS
message originates.
2. Select the Turn on LEDs option (within the LEDs (Light Emitting Diodes) section) to enable the
LEDs on Access Point. This parameter is not available for controllers or service platforms.
Select the Flash Pattern(2) option (within the LEDs (Light Emitting Diodes) field) to flash an
Access Point’s LED’s in a distinct manner (different from its operational LED behavior) to
allow an administrator to validate an Access Point has received its configuration from its
managing controller or service platform.
Enabling this feature allows an administrator to validate an Access Point has received its
configuration (perhaps remotely at the site of deployment) without having to log into the
managing controller or service platform. This feature is disabled by default.
3. Select the Capable option (within the RF Domain Manager section) to designate this specific
profile managed device as being capable of being the RF Domain manager. The default value
is enabled.