Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 834)

822 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
FIGURE 50 Wireless Controller - Power Status screen
The Power Status provides the following information for supported controllers or service platforms:
Device Displays the administrator assigned device name for the controller or service platform.
Temperature Displays the internal system temperature for the controller or service platform.
PoE Enabled Displays whether or not Power over Ethernet (PoE) is enabled for the controller or service platform.
When enabled, the controller or service platform supports 802.3af PoE on each of its ge ports. The
PoE allows users to monitor port power consumption and configure power usage limits and
priorities for each ge port.
Power Limit Displays the total watts available for Power over Ethernet on the controller or service platform. The
value should be between 0 - 40 watts.
Port Name Displays the GE port name on the controller or service platform.
Priority Displays the power priority for the listed port as either Critical, High or Low. This is the priority
assigned to this port versus the power requirements of the other supports available on the
controller or service platform.
System Voltage Displays the total current system voltage for the controller or service platform.
System Guard Band Displays the amount of voltage allocated to a System Guard Band. A System Guard Band is an
amount of voltage allocated to prevent power loss or cycling on connected PoE devices when the
power draw goes above the PoE Power Budget.
Power Budget Displays the total amount of voltage on the controller or service platform allocated for use in Power
over Ethernet.