Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 245)

Brocade Mobility RFS Controller System Reference Guide 233
53-1003099-01
5
4. Set the following Light Sensor settings for the BR1240’s sensor module:.
5. Enable or disable the following BR1240 Environmental Sensors:
6. Define or override the following Shared Configuration settings:
7. Select OK to save the changes and overrides made to the environmental sensor screen. Select
Reset to revert to the last saved configuration.
Overriding a Profile’s Advanced Configuration
Refer to profile’s advanced set of configuration screens to set client load balance calculations and
ratios, set a MiNT configuration and set other miscellaneous settings. For more information, refer
to the following:
• Advanced Profile Client Load Balance Configuration
• Advanced MiNT Protocol Configuration
• Advanced Profile Miscellaneous Configuration
Advanced Profile Client Load Balance Configuration
Overriding a Profile’s Advanced Configuration
Set a the ratios and calculation values used by Access Points to distribute client loads both
amongst neighbor devices and the 2.4 and 5 GHz radio bands.
To define Access Point client load balance algorithms:
Enable Light Sensor Select this option to enable the light sensor on the module. This setting is enabled by default. The
light sensor reports whether the BR1240’s deployment location has its lights powered on or off.
Polling Time to Determine
if Light is
On/Off Define an interval in Seconds (2 - 201) or Minutes (1 - 4) for the sensor module to poll its
environment to assess light intensity to determine whether lighting is on or off. The default polling
interval is 11 seconds. Light intensity is used to determine whether the Access Point’s deployment
location is currently populated with clients.
Shutdown WLAN Radio at
Low Limit of Light
Threshold Select this option to power off the BR1240’s radio’s fall below the set threshold. If enabled, select
All (both BR1240 radios), radio-1 or radio-2.
Low Limit of Light
Threshold Set the low threshold limit (from 0 - 1,000 lux) to determine whether the lighting is off in the
BR1240’s deployment location. The default is 100.
High Limit of Light
Threshold Set the upper threshold limit (from 100 - 10,000 lux) to determine whether the lighting is on in the
BR1240’s deployment location. The default is 500.
Enable Temperature
Sensor Select this option to enable the module’s temperature sensor. Results are reported back to the
Access Point’s Environment screens within the Statistics node. This setting is enabled by default.
Enable Motion Sensor Select this option to enable the module’s motion sensor. Results are reported back to the Access
Point’s Environment screens within the Statistics node. This setting is enabled by default.
Enable Humidity Sensor Select this option to enable the module’s humidity sensor. Results are reported back to the Access
Point’s Environment screens within the Statistics node. This setting is enabled by default.
Polling Interval for All
Sensors Set an interval in either Seconds (1 - 100) or Minutes (1 - 2) for the time between sensor
environmental polling (both light and environment). The default setting is 5 seconds.