Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 720)

708 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
14
2. Set the following file management source and target directions as well as the configuration
parameters of the required file management activity:
3. Select Copy to begin the file transfer. Selecting Reset reverts the screen to its last saved
configuration.
Restarting Adopted APs
Device Operations
Adopted devices may periodically require restarting to implement firmware updates or other
maintenance activities.
NOTE
The Adopted Device Restart tab is not available at the RF Domain level of the UI’s hierarchal tree. A
RF Domain must be selected and expanded to display the RF Domain’s member devices. Once
expanded, selected a RF Domain member device to ensure the Adopted Device Restart option is
available.
Source Select the source of the file transfer.
Select Server to indicate the source of the file is a remote server.
Select Local to indicate the source of the file is local to this controller or service platform.
File If the source is Local, enter the name of the file to be transferred.
Protocol Select the protocol for file management. Available options include:
•
tftp
•
ftp
•
sftp
•
http
•
cf
•
usb1-4
This parameter is required only when Server is selected as the Source.
Port Specify the port for transferring files. This option is not available for cf, and usb1-4. Enter the port
number directly or use the spinner control.
This parameter is required only when Server is selected as the Source.
Host If needed, specify a hostname or numeric IP address of the serve transferring the file. This option is
not valid for cf and usb1-4. If a hostname is provided, an IP Address is not needed.
This field is only available when Server is selected in the From field.
User Name Provide a user name to access a FTP or a SFTP server.
This parameter is required only when Server is selected as the Source, and the selected protocol is
ftp or sftp.
Password Provide a password to access the FTP or SFTP server.
This parameter is required only when Server is selected as the Source, and the selected protocol is
ftp or sftp.
Path / File Define the path to the file on the server. Enter the complete relative path to the file.
This parameter is required only when Server is selected as the Source.
Target Select the target destination to transfer the file.
•
Select Server if the destination is a remote server, then provide a URL to the location of the
server resource or select Advanced and provide the same network address information
described above.
•
Select Local if the destination is this controller or service platform.