Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 445)

Brocade Mobility RFS Controller System Reference Guide 433
53-1003099-01
8
NOTE
If connecting an Ethernet port to another Ethernet port, the pseudowire type must be Ethernet port,
if connecting an Ethernet VLAN to another Ethernet VLAN, the pseudowire type must be Ethernet
VLAN.
To define an L2TPV3 configuration for an Access Point profile:
1. Select Configuration > Profiles > Network.
2. Expand the Network menu to display its submenu options.
3. Expand the Network menu and select L2TPv3.
The General tab displays by default with additional L2RPv3 Tunnel and Manual Session
tabs available.
FIGURE 30 Network - L2TPv3 screen, General tab
4. Set the following General Settings for a L2TPv3 profile configuration:
Host Name Define a 64 character maximum host name to specify the name of the host that’s sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP and
SCCN) with the peer. Tunnel IDs and capabilities are exchanged during the tunnel
establishment with the host.
Router ID Set either the numeric IP address or the integer used as an identifier for tunnel AVP
messages. AVP messages assist in the identification of a tunnelled peer.
UDP Listen Port Select this option to set the port used for listening to incoming traffic. Select a port from 1,024
- 65,353.
Device Type Select this option to enable or disable bridge packets between two tunnel end points. This
setting is disabled by default.