Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 818)

806 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
15
2. Select a Wireless Controller node from the left navigation pane.
3. Select AP Detection from the left-hand side of the UI.
FIGURE 39 Wireless Controller - AP Detection screen
The AP Detection screen displays the following:
Wireless Clients
Controller Statistics
Unsanctioned AP Displays the MAC address of unsanctioned APs detected within the controller or service platform
radio coverage area. Unsanctioned APs are detected APs without deployment approval.
Reporting AP Lists the Access Point whose radio detected the unsanctioned AP. The Access Point displays as a
link that can be selected to display configuration and network address information in greater detail.
SSID Displays the SSID of each unsanctioned AP.
AP Mode Displays the operating mode of the unsanctioned device.
Radio Type Displays the unsanctioned AP’s radio type. The radio can be 802.11b, 802.11bg, 802.1bgn,
802.11a or 802.11an.
Channel Displays the channel where the unsanctioned AP was detected.
RSSI Lists the Received Signal Strength Indicator (RSSI) for each listed AP.
Last Seen Displays when the unsanctioned AP was last seen by the detecting AP.
Clear All Select Clear All to clear all the screen’s statistic counters and begin detecting new Access Points.
Refresh Select Refresh to update the statistics counters to their latest values.