Bridge vlan – Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 471
Brocade Mobility RFS Controller System Reference Guide
459
53-1003099-01
8
FIGURE 48
Forwarding Database screen
4. Define a Bridge Aging Time between 0, 10-1,000,000 seconds.
The aging time defines the length of time an entry remains in the a bridge’s forwarding table
before being deleted due to inactivity. If an entry replenishments a destination generating
continuous traffic, this timeout value will never be invoked. However, if the destination
becomes idle, the timeout value represents the length of time that must be exceeded before
an entry is deleted from the forwarding table. The default setting is 300 seconds.
5. Define a L3e Lite Entry Aging Time between 10-1,000,000 seconds.
The default setting is 300 seconds.
6. Use the + Add Row button to create a new row within the MAC address table.
7. Set a destination MAC Address address. The bridge reads the packet’s destination MAC
address and decides to forward the packet or drop (filter) it. If it’s determined the destination
MAC is on a different network, it forwards the packet to the segment. If the destination MAC is
on the same network segment, the packet is dropped (filtered)
8. Define the target VLAN ID if the destination MAC is on a different network segment.
9. Provide an Interface Name used as the target destination interface for the target MAC address.
10. Select OK to save the changes. Select Reset to revert to the last saved configuration.
Bridge VLAN