Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1016)

1004 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
16
7. Select RF to display Access Point RF quality analytics.
FIGURE 12 Access Point Analytics - RF screen
8. Refer to the following RF analytics trended for a selected Access Point:
Analytic Event Monitoring
Display the Event Monitor on the bottom portion of the analytic display, at any time or place in the
user interface hierarchy, to review individual analytic events by their severity, originating device,
reporting module and timestamp (occurrence).
FIGURE 13 Analytic Event Monitor
RF Quality Index Displays the trended graph of the effectiveness of a selected Access Point’s RF environment as a
percentage of the connect rate in both directions. The RF quality index value can be interpreted as:
• 0 – 20 (Very low utilization)
• 20 – 40 (Low utilization)
• 40 – 60 (Moderate utilization)
• 60 and above (High utilization).
Signal to Noise Ratio Displays a selected Access Point’s connected client signal to noise ratio (SNR) and a time stamp of its
reporting. A high SNR could warrant power compensation to account for poorly performing Access Point
radios.
Retry Rate Lists the number of retry attempts for requesting client connections to the selected Access Point’s
radios.