Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 200)

188 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 85 VPN Quick Setup Wizard
Select Quick Setup from the VPN Wizard screen.
Provide the following quick setup information to configure a VPN tunnel:
Tunnel Name Provide a name for the tunnel. Tunnel name identifies the tunnel uniquely.
Tunnel Type Configure the type of the tunnel. Tunnel can be one of the following types:
•
Site-to-Site – This tunnel provides a secured connection between two sites
(default setting).
•
Remote Access – This tunnel provides access to a network to remote devices.
Select Interface Configure the interface to use for creating the tunnel. The following options are available:
•
VLAN – Configure the tunnel over a Virtual LAN interface. Use the spinner to configure the
VLAN number.
•
WWLAN – Configure the tunnel over the WWLAN interface.
•
PPPoE – Configure the tunnel over the PPPoE interface.
Traffic Selector (ACL) Configure ACLs that manage the traffic passing through the VPN tunnel. The following options are
available:
•
Source – Provide the source network along with its mask
•
Destination – Provide the destination network along with its mask.
Peer Configure the peer for this tunnel. The peer device can be specified either by its hostname or by its
IP address.