Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 516)

504 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
7. Select Add to create a new Bridge VLAN configuration, Edit to modify an existing configuration
or Delete to remove a configuration.
FIGURE 82 Security Source Dynamic NAT screen
8. Select the ACL whose IP rules are applied to this policy based forwarding rule. A new ACL can
be defined by selecting the Create icon, or an existing set of IP ACL rules can be modified by
selecting the Edit icon.
9. Use the IP Address Range table to configure IP addresses and address ranges used to access
the Internet.
NAT Pool Lists the names of existing NAT pools used with the Bridge NAT configuration. This displays only
when the Overload Type is NAT Pool.
Overload IP Lists the address used globally and collectively for numerous local addresses.
Overload Type Lists the overload type used with the listed IP ACL rule. Set as either NAT Pool, One Global
Address or Interface IP Address.
ACL Precedence Lists the administrator assigned priority set for the ACL. The lower the value listed the higher the
priority assigned to these ACL rules.
ACL Precedence Set the priority (from 1 - 5000) for the ACL. The lower the value, the higher the priority assigned
to these ACL rules.
Interface Lists the outgoing layer 3 interface on which traffic is re-directed. The interface can be an
Access Point wwan1 or pppoe1 interface. Traffic can also be redirected to a designated VLAN.
NAT Pool Displays the NAT pool used by this Bridge NAT entry. A value is only displayed only when
Overload Type has been set to NAT Pool.
Overload IP Lists whether a single global address collectively supports numerous local addresses.
Overload Type Displays the override type for this policy based forwarding rule.