Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 422)

410 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
8
VM Interface Configuration
Profile Interface Configuration
Mobility provides a dataplane bridge for external network connectivity for Virtual Machines (VMs).
VM Interfaces define which IP address is associated with each VLAN ID the service platform is
connected to and enables remote service platform administration. Each custom VM can have up to
a maximum of two VM interfaces. Each VM interface can be mapped to one of sixteen VMIF ports
on the dataplane bridge. This mapping determines the destination for service platform routing.
By default, VM interfaces are internally connected to the dataplane bridge via VMIF1. VMIF1 is an
untagged port providing access to VLAN 1 to support the capability to connect the VM interfaces to
any of the VMIF ports. This provides the flexibility to move a VM interface onto different VLANs as
well as configure specific firewall and QOS rules.
NOTE
VM interfaces are only supported for NX4500, NX6500 and NX9000 series service platforms.
To define a VM interface profile configuration:
1. Select Configuration > Profiles > Interface.
2. Expand the Interface menu to display its submenu options.
3. Select VM.
FIGURE 18 Profile - VM Interfaces screen