beautypg.com

Certificates – Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 967

background image

Brocade Mobility RFS Controller System Reference Guide

955

53-1003099-01

15

FIGURE 150

Access Point - VPN IPSec screen

5. Review the following VPN peer security association statistics:

Certificates

Access Point Statistics

The Secure Socket Layer (SSL) protocol ensures secure transactions between Web servers and
browsers. SSL uses a third-party certificate authority to identify one (or both) ends of a transaction.
A browser checks the certificate issued by the server before establishing a connection.

This screen is partitioned into the following:

Peer

Lists IP addresses for peers sharing security associations (SAs) for tunnel interoperability. When a peer
sees a sensitive packet, it creates a secure tunnel and sends the packet through the tunnel to its
destination.

Local IP Address

Displays each listed peer’s local tunnel end point IP address. This address represents an alternative to
an interface IP address.

Protocol

Lists the security protocol used with the VPN IPSec tunnel connection. SAs are unidirectional, existing in
each direction and established per security protocol. Options include ESP and AH.

State

Lists the state of each listed peer’s security association.

SPI In

Lists stateful packet inspection (SPI) status for incoming IPSec tunnel packets. SPI tracks each
connection traversing the IPSec VPN tunnel and ensures they are valid.

SPI Out

Lists SPI status for outgoing IPSec tunnel packets. SPI tracks each connection traversing the IPSec VPN
tunnel and ensures they are valid.

Mode

Displays the IKE mode as either Main or Aggressive. IPSEC has two modes in IKEv1 for key exchanges.
Aggressive mode requires 3 messages be exchanged between the IPSEC peers to setup the SA, Main
requires 6 messages.

Clear All

Select the Clear All

button to clear each peer of its current status and begin a new data collection.

Refresh

Select the Refresh

button to update the screen’s statistics counters to their latest values.