Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 218)

206 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 99 Security Bridge NAT screen
6. Review the following Bridge NAT configurations to determine whether a new Bridge NAT
configuration requires creation or an existing configuration modified or removed.
7. Select Add to create a new Bridge VLAN configuration, Edit to modify an existing configuration
or Delete to remove a configuration.
Access List Displays the access list applying IP address access/deny permission rules to the Bridge
NAT configuration.
Interface Lists the communication medium (outgoing layer 3 interface) between source and
destination points. This is either the Access Point’s pppoe1 or wwan1 interface or the
VLAN used as the redirection interface between the source and destination.
NAT Pool Lists the names of existing NAT pools used with the Bridge NAT configuration. This displays
only when Overload Type is NAT Pool.
Overload IP Lists the address used globally for numerous local addresses.
Overload Type Define the overload type utilized when several internal addresses are NATed to only one or
a few external addresses. Set as either NAT Pool, One Global Address or Interface IP
Address.
ACL Precedence Lists the administrator assigned priority set for the ACL. The lower the value listed the
higher the priority assigned to these ACL rules.