Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 256)

244 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
1. Select Configuration > Devices > Auto Provisioning Policy.
2. The Auto-Provisioning screen displays by default.
FIGURE 124 Auto-Provisioning screen
Use the Auto Provisioning screen to determine whether an existing policy can be used as
is, a new Auto Provisioning Policy requires creation or an existing policy requires edit or
deletion.
3. Review the following Auto Provisioning parameters:
4. Select Add to create a new Auto Provisioning Policy, Edit to revise an existing Auto Provisioning
Policy or Delete to permanently remove a policy. For instructions on either adding or editing an
Auto Provisioning Policy, see
Configuring an Auto Provisioning Policy .
Configuring an Auto Provisioning Policy
Cluster Configuration Overrides (Controllers and Service Platforms Only)
Auto Provisioning Policies can be created or refined as unique deployment requirements dictate
changes in the number of Access Point radios within a specific radio coverage area.
To add a new Auto Provisioning Policy or edit an existing Auto Provisioning Policy configuration:
1. From the Adoption screen, either select Add or select an existing Auto Provisioning Policy and
select Edit.
2. If adding a new Auto Provisioning Policy, provide a name in the Auto Provisioning Policy field.
The name must not exceed 32 characters. Select Continue to enable the remaining
parameters of the Auto Provisioning Policy screen.
The Rules tab displays by default.
Auto Provisioning Policy Lists the name of each policy when it was created. It cannot be modified as part of the Auto
Provisioning Policy edit process.
Adopt if No Rules Match Displays whether this policy will adopt devices if no adoption rules apply. Double-click within this
column to launch the edit screen where rules can be defined fro device adoption. This feature is
enabled by default.