Allied Telesis AT-S62 - Manual (Page 811)

AT-S62 User’s Guide
Section VIII: Web Browser Management 811
IP Address and Encryption Key
Use these fields to specify the IP addresses and encryption
secrets of up to three network servers containing TACACS+
server software. You can leave an encryption field blank if you
entered the server’s secret in the Global Secret field.
c. After you have finished configuring the parameters, click Apply.
d. To enable the authentication feature on the switch, click the
Enable Server-based Authentication check box. A check in the box
indicates that this feature is enabled. No check indicate the
feature is disabled. The default is disabled.
e. To permanently save the changes, use the Save Changes button
in the General tab. For directions, refer to Saving Your Parameter
Changes on page 577.
6. To configure RADIUS, do the following:
a. In lower section of the Server-based Authentication tab, click
RADIUS Configuration and click Configure.
The RADIUS Client Configuration page is shown in Figure 297.
Figure 298 RADIUS Configuration Page
b. Configure the parameters as needed. They are described below.
Global Encryption Key
If all of the TACACS+ servers have the same encryption secret,
you can enter the key here. If the servers have different keys,
you must specify each key when you specify a server’s IP
address.