Allied Telesis AT-S62 - Manual (Page 317)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 317
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 86 on page 311.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure
87 on page 315.
4. To change the Transport Tag, type 3 to select Set Transport Tag.
The following prompt is displayed:
Enter Community Index:
5. Enter the Community Index of the Transport Tag you want to change.
The following prompt is displayed:
Enter Transport Tag:
6. Enter the new value for the Transport Tag.
Enter a name of up to 32-alphanumeric characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Storage Type
To modify the Storage Type parameter in an SNMPv3 Community Table
entry, perform the following procedure:
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 86 on page 311.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure
87 on page 315.
4. To change the Storage Type, type 4 to select Set Storage Type.