Allied Telesis AT-S62 - Manual (Page 696)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 696
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
❑ Creating an Access Table on page 696
❑ Deleting an Access Table Entry on page 700
❑ Modifying an Access Table Entry on page 701
For reference information about the SNMPv3 Access Table, see
Configuring the SNMPv3 Access Table on page 696.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.